Page 1 of 2
quality lathe work
Posted: Wed Feb 05, 2014 8:15 pm
by Moogling
Some of the last bits for Ellie (my IIB) turned up today
Wheel studs for holding the step on - with the earlier type thread (double sided nuts)
A bit of a plug for
Abtech Engineering who did this work for me!
Re: quality lathe work
Posted: Wed Feb 05, 2014 9:30 pm
by lanceley
Almost too pretty to use a mere wheel nuts.....
Re: quality lathe work
Posted: Wed Feb 05, 2014 10:16 pm
by Moogling
Agreed!
Re: quality lathe work
Posted: Wed Feb 05, 2014 10:50 pm
by DasLandRoverMan
You're bringing sexy back...
Re: quality lathe work
Posted: Thu Feb 06, 2014 4:24 pm
by Wheeledbeast
Oooooooh Shiney
…..
Are they stainless or just polished up
Re: quality lathe work
Posted: Thu Feb 06, 2014 7:14 pm
by Moogling
just mild, not polished at all as far as I can tell, but clean
very pleased! I asked for 6 and they gave me 8
Re: quality lathe work
Posted: Thu Feb 06, 2014 7:57 pm
by parksy64
Nice!
Re: quality lathe work
Posted: Wed Feb 12, 2014 11:52 pm
by eastern101
Nice I'm now possibly getting some made up for my 101 deeper ones to bring step out further in deeper offset rims.
Re: quality lathe work
Posted: Thu Aug 07, 2014 9:37 pm
by MikeD
Hi moogling,
I know this is an old thread, but i'm looking to get some extended nuts made up myself, do you mind if i ask how much (roughly) you paid to get them done? Just so i know if i'm being seen off...
Thanks
Mike
Re: quality lathe work
Posted: Fri Aug 08, 2014 6:35 pm
by Moogling
I paid £100 to a local chap who does work for my mothers company. I don't know if that was expensive or cheap, but I was happy.