900 Club Forum

Does anyone have a copy of the winch installation instructions that were in the back of the old manuals? I can't remember if it was the workshop book or the optional parts book, but it's the one with all the drilling locations and diameters etc.

Thanks.

Anyone?

yes, message me your email address and i'll send them to you.
william

Did I ever mention I wanted one of these. Sniff, people can be so hurtful.

Did you get sorted with hydraulic winch fitting instructions in the end Dan?

Felix123 wrote:Did you get sorted with hydraulic winch fitting instructions in the end Dan?

I did, William kindly sent me a copy. What is odd though is that my setup actually had a few differences, mainly to the valve block, but nothing insurmountable.

This thread was only put up to upset. The world's a cruel place.

fuckwit wrote:This thread was only put up to upset. The world's a cruel place.

Keep an eye on ebay, although I would wager you would be better off buying a vehicle with the winch complete, as I do not recall ever seeing a complete kit on ebay for example.

I'm going to put 42A's old winch (complete set up) soon, to raise funds for a chassis. Same as your bar the valve block I think.

There you go then Mr Wit! ^^